[. . . ] Do not damage the tubes If the tubes are damaged: Keep naked flames and Ignition sources away from the appliance. Avoiding placing children and vulnerable people at risk At risk are: Children, People who have limited Physical, mental or sensory abilities, People who have inadequate knowledge concerning safe operation of the appliance. measures: Ensure that children and Vulnerable people have understood the hazards. Children or vulnerable people must be supervised by a responsible person when using the appliance. [. . . ] Note: The arrangement of the features does not affect the energy consumption of the appliance. Install the appliance as far away as possible from heating elements, cooker and other heat sources: 3 cm to electric or gas cookers. Note: If this is not possible, attach an insulating plate between the appliance and heat source. The appliance must cool less frequently at low ambient temperatures and therefore consumes less power. The air on the rear panel of the appliance does not The appliance consumes less power if the warm air can escape. Individual parts of the appliance become hot during Touching these parts may result in burns. Transport purchased food in a cool bag and place quickly in the appliance. The appliance must cool less frequently and therefore consumes less power. Allow warm food and drinks to cool down before placing in the appliance. Thaw frozen food in the refrigerator compartment in order to utilise the low temperature of the frozen food. Always leave a space between the food and the rear The air can circulate and the air humidity will The appliance must cool less fre- Quently and therefore consumes less power. The air on the rear panel of the appliance does not warm up so intensely. Before using your appliance for the first time Fold out the last page with the ecnailparuoywonkotgniteG diagrams. Note: You can connect the appliance to mains-controlled and sine-controlled inverters. Mains-controlled inverters are used for photovoltaic systems which are connected directly to the national grid. On ships or in mountain lodges, which are not connected directly to the national grid. After installing the appliance, wait at Least 1 hour before connecting it to The socket must comply with the Outside Europe: Check whether the Indicated current type of the Appliance specifications are on the The socket must be freely You can vary the shelf: Pull out and remove the shelf. You can remove the container: Pull out the container all the way, lift You can remove the storage compartment: Lift up storage compartment and After the appliance has been switched on, it may take several hours until the set temperatures have been reached. Do not put in any food until the selected temperature has been reached. Switching off and disconnecting the appliance The appliance no longer cools. Pull out the mains plug or switch off Keep pressing the button °C until the display indicates the required temperature. You can use sticker OK to check whether the temperature in the refrigerator compartment reaches +4 °C or lower. [. . . ] The condensation runs from the condensation channel to the evaporation pan where it evaporates. Note: Keep the condensation channel and drainage hole clean so that the condensation can drain and odours do not form. Pull out the mains plug or switch off Take out the food and store in a cool location. Clean the appliance with a soft cloth, lukewarm water and a little pH-neutral washing-up liquid. [. . . ]